• Full cone spray pneumatic nozzle …
Ultra-Compact Size, Small Capacity Fine Fog Nozzles/ Flat Spray SCBIMV series nozzles
|Thread standard||Pipe conn. size||M3 depth 2.5 (Air inlet/pilot air), M3 depth 3 (Liquid inlet)||Standard pressure||-|
|Spray angle||110°, 80°, or 45°*||Spray capacity||0.25–4.0 ℓ/hr||Supply air type||Compressed air|
|Liquid feeding system||Liquid pressure||Mean droplet diameter||20–100 μm**||Air consumption||2.6–12.4 ℓ/min, Normal|
|Air pressure||0.2–0.4 MPa||Free passage diameter||0.1–0.3 mm (Spray orifice)|
• Flat spray pneumatic nozzle producing fine atomization with a mean droplet diameter of 100 μm or less.**
• Ultra-compact size. About 42 mm in total length including control adaptor.
• Features large turn-down ratio under liquid pressures of 0.1–0.3 MPa.
• Produces two different spray distributions: uniform spray distribution throughout spray pattern area (when spraying at a low air-water ratio), or a mountain-shaped distribution having gradually tapered edges (at a high air-water ratio).
• Spray angle of 110ﾟ, 80ﾟ, or 45ﾟ.*
• Capable of spraying smallest flow rate among all of our pneumatic spray nozzles.
• Spray ON/OFF can be regulated by switching the pilot air ON/OFF (adaptor type SP) or by turning compressed air ON/OFF (adaptor type SN).
*Spray angle measured at compressed air pressure of 0.3 MPa and liquid pressure of 0.1 MPa.
**Mean droplet diameter measured by Laser Doppler Method.
Spraying: Mold release agent, lubricant, deodorant (trash pit, refuse collector, inlet conduit), oil, surface treatment agent, rust preventive, honey, insecticide, aqueous urea, etc.
Cooling: Dies, gas, glass, steel plates, steel pieces, moldings, automobile bodies, plastic products, etc.
Moisture control: Paper, gas, ceramics, concrete, etc.
Cleaning: Printed circuit boards, glass tubes, etc.
Others: Dust suppression, catalyst denitration, etc.
Industries in which this nozzle is used
Steelmaking, Electronics, Paper & pulp, Printing, Food, Automotives
|Structure||• Comprising seven parts: Spray tip, core, cap, connector, adaptor, packing, and spring cap.
• Connecting adaptor (spray ON/OFF control adaptors) are available from the type SP or SN.
• Internal mixing type designed to mix compressed air and liquid inside the nozzle (Inner air type: compressed air flows in the center of the nozzle, while liquid flows along its circumference).
• Liquid pressure type.
|Material||• Stainless steel 303 (Packing: FKM)|
*1) Hole φ1 is for air relief.
*2) No pilot air for SN-type adaptor.
• Appearance and dimensions may differ depending on nozzle codes and materials. Please contact us for details.
People who viewed this Item also viewed the Items below.
• Flat spray pneumatic nozzle produ…