| Thread standard | - | Pipe conn. size | - | Standard pressure | - |
|---|---|---|---|---|---|
| Spray angle | 80° (*1) | Spray capacity | 0.5–5.5 ℓ/hr | Supply air type | Compressed air |
| Liquid feeding system | Liquid siphon | Mean droplet diameter | 20–30 μm | Air consumption | 15–92 ℓ/min, Normal |
| Air pressure | 0.2–0.4 MPa | Free passage diameter | 0.3–0.7 mm (*2) | ||
• Flat spray pneumatic nozzle producing fine atomization with a mean droplet diameter of 30μm or less (*3).
• Liquid siphon feed type (liquid pressure device is not required).
• Even spray distribution across the entire spray area.
• Spray angle of 80ﾟ.
*1) Spray angle measured at compressed air pressure of 0.3 MPa and liquid siphon height of 100 mm.
*2) Free passage diameter of nozzle orifice.
*3) Measured by Laser Doppler Method.
Spraying: Mold release agent, lubricant, deodorant (trash pit, refuse collector, inlet conduit), oil, surface treatment agent, rust preventive, honey, insecticide, aqueous urea, etc.
Cooling: Dies, gas, glass, steel plates, steel pieces, moldings, automobile bodies, plastic products, etc.
Moisture control: Paper, gas, ceramics, concrete, etc.
Cleaning: Printed circuit boards, glass tubes, etc.
Others: Dust suppression, catalyst denitration, etc.
• Steelmaking
• Pollution control
• Electronics
• Paper & pulp
• Printing
• Food
• Automotives
| Structure | • Comprising four parts: Nozzle tip, core, cap, and adaptor. • Connecting adaptors are available from eight types (N, T, NDB, SPB, SNB, and ball joint type of UNDB, USPB, USNB) including the ones which can regulate spray ON/OFF and adjust spray direction. Please see our catalog for details. • Internal mixing type designed to mix compressed air and liquid inside the nozzle (Inner air type: compressed air flows in the center of the nozzle, while liquid flows along its circumference). • Liquid siphon feed type. |
|||||||||||||||||||||||||||||||||||||||
|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|
| Material | • Stainless steel 303 [Optional material] Stainless steel 316L |
|||||||||||||||||||||||||||||||||||||||
| Mass |
・Details of adaptors are shown on the catalog.
|
|||||||||||||||||||||||||||||||||||||||
• Mounting bracket enables easy fixing of BIM nozzle on a pole with desired spray direction.
• Please indicate "with φ8 mounting bracket" or "with φ10 mounting bracket" at the end of nozzle description when you order.
• This photo shows a BIM nozzle with mounting bracket installed on a pole.
• Flat spray pneumatic nozzle produ…
• Flat spray pneumatic nozzle produ…
